Cobra MPC SERIES Manuel d'utilisateur télécharger pdf (Page 6)

COBRA INSTALLATION AND PROGRAMMING GUIDE

Installing the Cobra

57010-H Page 6 12-19-2005

7) Install the Outside Escutcheon:

8) Install the Inside Baseplate Assembly:

• If necessary, apply exterior gasket (EG

option) to surface (a).

• Insert the round end of the spindle* (b)

into the outside escutcheon’s hub

assembly (c).

• Dot on cam (d) must be at the 6 o’clock

(bottom) position.

• From outside of door, feed outside

escutcheon’s battery wire harness (e)

through hole (f) in door.

• Slide escutcheon against door.

Refer to the chart below to determine the

correct spindle to use.

•

serve t

e po

ty mar

ngs

e t

attery

(

)

install the 4, AA batteries (provided) accordingly.

• From inside of door, feed battery wire harness (b) through hole

in spacer (c) if needed *.

• Feed battery wire harness through hole in inside baseplate

assembly (d).

• Press baseplate (and spacer, if there is one) against door.

Spacer required on doors thinner than 1-1/2”.

spacer required on doors thinner than 1-1/2”

Order P/N: MPC-SK

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Cobra MPC SERIES Manuel d'utilisateur Page 6