Cobra 4400 Manuel d'installation télécharger pdf (Page 28)

USER AND FITTING INSTRUCTIONS 4400

OFF

IGN +15

HOW TO START PROGRAMMING

ALARM

SYSTEM

DISARMING

HOW TO GO OUT

HOW TO CHANGE LINE

HOW TO ACTIVATE/DEACTIVATE A FUNCTION

OFF

HOW TO CHANGE TABLE

1 FLASH

8 - Coupling of modules / siren 4310 / satellite alarm ICD 213X

on Cobra Bus line.

On the Cobra Bus line (pin 10) it is possible to connect the following

additional modules (Siren 4310 / anti - lifting module / satellite alarm

ICD 213X / Engine lock 8509) by means of the following programming

procedure:

1. disconnect system,

2. enter programming mode using the dedicated procedure

for the product,

3. move from page 2 to page 7 by activating and de - activating

the panel (+15 ON / OFF),

4. the storage and completion of programming is signalled by

flashing indicator lights.

NOTE: if two 8509 modules are to be connected, it is necessary

to memorize one module first then exit the programming mode,

and then repeat the operation for the second one by re-entering

the programming mode.

Repeat from point 1 if a module of the Cobra Bus line is disconnected.

NOTE: with the alarm disarmed, if a module self-learned by the

Cobra Bus line is disconnected, when the system is armed there

will be 8 to 12 signalling flashes of the direction lights; if it is

activated, there will be 8 to 12 Buzzer signals.

IMPORTANT: if the KIT includes a 4310 siren with backup battery,

it is not necessary to carry out the inclusion procedure as it has

already been included in the factory.

9 - PROGRAMMING

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 44 45

Pas de commentaire

Cobra 4400 Manuel d'installation Page 28